Mounting Shutters On Vinyl Siding

The top of the low end standardsized vinyl siding lo and industry experts predict that you need to go if.

Mounting shutters on vinyl siding.

Also drill the hole in the siding 1 4 inch larger than the fastener. To avoid warping don t attach the shutters tightly. Overtightening fasteners during shutter installation can create warping or dimples on the surface of vinyl. To remove shutters do not attempt to pull out the shutter spikes.

Use a level to ensure that you are hanging shutters at an even height on either side of each window. Best solid surface shower pan to be about inches high. Do not over tighten or this will cause the shutter to dimple. Mark the locations of the mounting holes on the building.

Push shutter locks through the holes in the shutter and into the hole in the wall surface. But the only way to fasten the shutters is to drill into the siding. Reposition the shutter. So i don t really want to do that because if it doesn t work out then i have holes in my siding.

How to hang shutters on vinyl siding attach the shutters may end standardsized vinyl and inch diagonally from the market. Tap the shutter fastener gently with a hammer to snug the shutter against the siding. For wood vinyl or aluminum siding drill a 1 4 diameter hole through just the siding. Grasp the shutter fastener supporting shank and push it through the shutter hold and into the wall surface.

Use a hammer to gently tap the fasteners to snug the shutter to the siding. So what i wanted to do is i wanted to put shutters on the house but i m not sure which color or which style. Most vinyl siding is made to imitate wood lap siding so the lap of the siding is measured at the bottom of the simulated wood panel where the real wood would overlap each other. Measure the thickness of the lap on the siding.

Installing in vinyl siding. Be careful not to drill into the wall. Repeat this process for each shutter you ll be installing. Measure the same distance upward from the bottom of your shutters and make a mark on your siding for the next screw.

Step 3 add these two measurements together then add 1 2 inch. You ll need a masonry bit and masonry wall anchors or suitable spikes if provided with shutters.